Boat Plans Wooden
The epoxy on the chinelogs took well, the scarf is a success as far as Im concerned. Once I sanded down the excess epoxy the joint looks clean and tight, Im happy with the result. Today I placed the chinelogs in position onto the sides of the boat. I did things a little opposite because Im by myself and I was trying to make the operation go smoothly and precisely. I placed the bow piece 5cm back as dictated by the plans, with 1cm overhang the bottom edge, and screwed it in place. I placed a total of 6 position screws that are not designed to provide the clamping power, I used clamps instead. I get the feeling that the plans call for screws to be pushed through from the outside of the hull, but I felt Id have more control over the chinelogs if I did everything facing them. I was careful to place the screws in hidden locations, behind BHs, in watertight tanks, etc. I have pretty much 1cm throughout the length of the side, with a few locations with 1mm variations, of which Im ok with. A pre-coat of epoxy, then thickened epoxy application, clamps, clean up (difficult), and viola:
All I have left to do now is put together that stem and I can do a dry-fit.
Do you find information about Boat Plans Wooden are you looking for? If not, below may help you find more information about the Boat Plans Wooden. Thank you for visiting, have a great day.
0 komentar:
Posting Komentar