Boat Plans Pdf
Today I planed down the chinelogs to flat, in order to fit the bottom at some point in the near future. Unfortunately for me, something somewhere didnt add up.
When I cut the notches in my BHs, I was very careful to use an actual slice from my chinelog to trace a pattern for the notch. Somehow, my notches were too deep laterally, I have gaps there that need filling. Today I now realize that they are also too shallow vertically... after planing the chinelogs flat, I have a gap between the bottom of the BHs and the chinelog. Take note from BH3:
When I fit the bottom onto the boat, the gap is clear (boat is upside down):
This is especially frustrating because:
1: I measured the notches using an actual piece from the chinelog
2: I was very careful to do my best eye-balling job that the bottom of the ply appeared to meet the bottom of the BHs
In retrospect I should have:
1: After the dry-fit turn the hull upside down to get a good look at what was going on
2: Do a test plane portion to see where a flat chinelog ends up in relation to the BHs
So now I can do one of three things:
1: Fill the gap with loads and loads of epoxy when I put on the bottom
- Risky because I could deform the bottom if I screw too hard placing it into position
2: Fill the gap with a strip of wood that is painstakingly cut and glued into place
-Annoying work, AND it wont match the BH bottom frame
3: Continue to plane down the chinelogs until they match the BHs.
-I lose freeboard AND it could make the boat too wide at the bottom and the pre-cut ply for the bottom wont be able to accomodate the new width.
For all its worth, heres the boat with the bottom kinda on:
Ive just decided that solution #3 is not a good one.
I have now just decided to go with option #2.
Interestingly enough, BH1 came out perfect!... WTF, Over?
Do you find information about Boat Plans Pdf are you looking for? If not, below may help you find more information about the Boat Plans Pdf. Thank you for visiting, have a great day.
0 komentar:
Posting Komentar